Snare Drum Recording Tips
Go to: Previous Article Next Article
Recording The Snare Drum: First, make steadfast your snare drums tuning pegs are tuned right. Its for the most part the drummers call. He will know when it sounds and feels precise. Your snare drum also has distinct sounds to it, depending on the location being hit by the drum stick. If your drummer is clumsy, take it into evidence and hit the snare head in all the unlike locations to investigation its sound. You dont want to patch it in the mix or in the audio mastering
stage
As far as mic's go, there are many to chose from, but for this discussion, I'm indicating the good ole SM57 for the top of the snare head. Place it form a few centimeters to an inch above the edge of the snare head. You can get away with using just one mic, but why settle for good sound when you can have great sound! So the base of the snare head must be mic'ed. Chose a mic that is good at picking up the mid-high to high frequencies, like an AKG 451B small diaphragm mic. Due to the small size of this mic, its an out of sight fit under your snare drum. When using 2 mics for the snare drum or any other instrument, you need to test the phase. If the mic's are out of phase, you can try moving the position of one of the microphones to get both microphones in phase with each other.
You may need to alter the phase of one of the mic's if you cannot get both mic's in phase with each other. These two mic's collectively are a great match because the SM-57 is great for the low-mids to mid range and the AKG is great for picking up the mid-high to high frequencies. Its a match made in "snare drum heaven". EQ'ing The Snare Drum: (Note: These are just suggestions and instructions, as nothing is written in stone. You must use your ears, as each song will need different EQ settings. Put oneself out using a high-pass filter set at 120Hz and under. 120Hz is a great opening point and then just slide the filter lower for desired cut. Boost between 150 - 300Hz. This will fatten the snare drum up for you. Try cutting around 400 - 900Hz to eliminate some boxiness low end Boost between 5 - 7kHz for a crispness A boost between 9 - 15kHz will add some nice brilliance to the snare. Just make sure it doesn't interfere with the vocals in that range.
Article Source: Articlelogy.com
Insurance Comparison Quotes - Selected Insurance Carriers eager to quote you a price, fast!-
Word Count: 438
Reduce Your Debts Without Bankruptcy. See How Much You Can Save. Free Debt Analysis
